La sessione di domande e risposte di oggi ci viene fornita per gentile concessione di SuperUser, una suddivisione di Stack Exchange, un raggruppamento di domande e risposte di community drive.
La domanda
Lettore SuperUser oKtosiTe ha notato l'etichetta di avvertenza e aveva bisogno di arrivare al fondo delle cose:
On many hard drives, there’s a text warning to “not cover this hole”, sometimes adding that doing so will void the warranty.
What is the purpose of this hole and why would covering it cause damage or increase the likelihood of drive failure?
Per fortuna non sono stati richiesti studi sul campo o annullamenti della garanzia per risolvere il mistero.
La risposta
Immagine gentilmente concessa da Oliver Salzburg, collaboratore di SuperUser.
Il contributo di SuperUser music2myear offre alcune informazioni sul piccolo foro e sull'importanza di lasciarlo senza ostacoli:
It allows for equalization of air pressure between the inside and outside of the drive. While it is not a complete pass-through of outside air into the HDD internals, there is a filter inside the hole that allows the air pressure to equalize.
If the drive were completely sealed, operating at altitudes significantly different from those the drive was manufactured and sealed at, it would cause problems and increase the likelihood of catastrophic failures.
This system works in much the same way as the Eustachian tubes that allow our ears internal pressures to equalize, preventing the explosion of our ear drums.
Dennis espande questa spiegazione indirizzandoci verso la sezione di Wikipedia che si occupa dell'integrità del disco rigido:
Check out the Wikipedia hard drive entry paying attention to the Integrity section with reference to the “breather hole”:
Hard disk drives require a certain range of air pressures in order to operate properly. The connection to the external environment and pressure occurs through a small hole in the enclosure (about 0.5 mm in breadth), usually with a filter on the inside (the breather filter). If the air pressure is too low, then there is not enough lift for the flying head, so the head gets too close to the disk, and there is a risk of head crashes and data loss. Specially manufactured sealed and pressurized disks are needed for reliable high-altitude operation, above about 3,000 m (9,800 ft).[99] Modern disks include temperature sensors and adjust their operation to the operating environment. Breather holes can be seen on all disk drives-they usually have a sticker next to them, warning the user not to cover the holes.
La sola menzione di headcrashes (e l'orribile memoria dei suoni fatti dall'ultima unità di crash persa-a-testa) sono più che sufficienti per noi.
Hai qualcosa da aggiungere alla spiegazione? Sound off nei commenti. Vuoi leggere più risposte dagli altri utenti di Stack Exchange esperti di tecnologia? Controlla la discussione completa qui.
